BEST
LED/UV Lamp for Curing - Galaxy700 Low Heat
RSD10,750
GALAXY700 professional lamp for curing UV and LED/UV products.
Thanks to the simultaneous double light source of 365nm (nanometer) and 405nm (nanometer), it is perfect for fast curing of:
- UV and LED/UV builder gels
- UV and LED/UV colour gels
- UV and LED/UV gel polishes
- UV and LED/UV top coats (matte or glossy)
FEATURES:
- 27 LED diodes
- Maximum lamp power: 48 W
- Input operation mode: AC 100-240 V, 50/60 Hz, 1 A
- Output operation mode: DC 24V 1.5 A
- Dimensions: 200 mm x 170 mm x 100 mm
- Timer: 30 s / 60 s / 90 s
- Low heat mode: 120 s
- Sensor time: 90 s
- Changeable bottom
CONTENTS OF THE BOX:
- GALAXY700 UV/LED lamp
- DC 24V adapter
- Protective transport components
- User manual
- Changeable bottom
- Three rubber front covers in different colours (pink, purple and white)
- Connect the adapter to the device and connect the adapter to the adequate power supply;
- Immediately after connecting the device to an electric circuit, a sensor becomes active, activating the diodes under the lamp once a hand is placed underneath, operating for 120 seconds;
- Once the hand is removed from the area, the light emission stops;
- Apart from the mode mentioned above, depending on the required length of gel or permanent polish curing, the lamp can have four other different modes:
- 10 seconds operation mode
- 30 seconds operation mode
- 60 seconds operation mode
- The “Low heat mode”;
- 10, 30 and 60 seconds operation modes are activated by pressing the designated mode activation button, marked with a corresponding label (10 s, 30 s or 60 s). Once the chosen mode has been selected, the diodes will emit light. After the set time expires, the diodes will stop emitting light;
- The “Low Heat Mode” is activated by shortly pressing the 90s button. This mode cures gels or permanent polishes for a total of 90 seconds, divided into three continuous phases:
- Phase one takes place with 1/3 of the total lamp power, lasting for 30 seconds
- Phase two takes place with 2/3 of the total lamp power, lasting from the 30th to the 45th second
- Phase three curing takes place with the lamp on full power. This phase starts from the 45th second and lasts until the 90th, after which the diodes stop emitting light;
- Each mode can be interrupted by pressing its activating button;
- Before the first use, removing the protective film from the reflecting surfaces is necessary.
Product name: UV/LED Lamp for Curing
Type/model: Galaxy700
Quantity: 1 pc
Made in China
Importer for Serbia: Alexandar DOO Novi Sad